Wow and flutter US.

AEP, UK, E model Dimensions Approx.

Weight Approx. 4.3 kg (9 lbs 802).

When the mech deck is operated with the set in an upside down position, misoperation may result.

For repair while operating the mech deck, perform with the set in its normal position or standing on its side.

The mains lead plug of your apparatus is a 3-pin type especially designed to be connected only to the Sony TA-AX22 or TA-AX44 amplifier.

These ampliliers have receptacles on the rear to receive this plug to supply mains power to other components of your audio system.

Connect the 3-pin plug only to the mains outlet on the compo-.

CAUTION nents mentioned above or to the supplied mains lead adaptor.

Important The wires in the mains lead adaptor are coloured in accordance with the following code.

Brown: Live As the colours of the wires in the mains lead adaptor of this ap- paratus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black, The wire which is coloured brown must be connected to the ten minal which is marked with the letter L or coloured red.

Before connecting the unit to the power source, check that the operating voltage of your unit is the same as the local power line voltage.

Note: The adjustment should be performed in the order given in this service manual.

CS-15 AUTO 1: NORM CS-25 AUTO II:Cr02 CS-30 Fe-Cr (METAL) III: Fe-CI CS-40 AUTO or IV: METAL.

DOLBY NR switch: OFF TAPE SELECT switch: AUTO (1: NORM) TIMER switch: OFF.

Deliver the standard input signal level to the input jack and set the REC LEVEL control to obtain the standard output signal level.

HEAD- LlNE OUT PHONES load impedance 47k) 80 output level 044V 31mV.

LFM-SO or digital frequency test rape counter WS48A (3kHz, odB n 47m 0 a.- LINE OUT Specification: Speed checker Digital frequency counter -l to 1 2970 7 3030 Hz.

Frequency difference between the beginning and the end of the tape should be within 1 (30Hz).

Sony Ta-Ax22 Service Manual